Introduction
Sometimes you need to cut out a hatch out of a bulkhead which needs to go back, so it’s better not to hack it up while cutting. Here is how we solved this problem in a simple way. The picture gallery:
-
- Take a hacksaw blade and break a little bit off. Fix this between two pieces of wood and apply pressure with a clamp until the blade bit is fixed tight. Go to phase 2.
-
- Use the composite tool to scratch a slit into the hatch outline. Remember to pull the way which the teeth cut. Usually hacksaw blades are unidirectional.
-
- Only cut with the composite tool until you have a slit wide enough to fit your jigsaw blade trough it. Then cut the hatch out. This is what the end product should look like. Nice and tightly cut.
